Puyallup, Washington
Washer repair in Puyallup, WA.
Standing water in the drum, a load that comes out soaked, a puddle on the laundry room floor, or a machine that won't start at all. Call and describe what your washer is doing, and we'll take it from there.
Phone calls only.
Service provided by Titan Appliance Service
Front-load and top-load
Household washers
Recognize the symptom
Common washer problems
Find what your machine is doing below. The causes listed are common possibilities, not a diagnosis. The actual fault is confirmed once the washer is inspected.
Won't drain
Water sits in the tub after the cycle ends, or clothes come out dripping instead of damp.
Possible causes
- Clogged drain pump or filter
- Kinked or blocked drain hose
- Failing pump motor
Won't spin
The washer fills and agitates, but the drum stays still or barely turns at the end of the cycle.
Possible causes
- Worn drive belt or motor coupling
- Faulty lid or door lock switch
- Drain issue stopping the spin
Leaking water
Puddles under or in front of the machine, damp floors, or drips from behind the cabinet.
Possible causes
- Torn door boot or gasket
- Loose or cracked hose
- Worn tub seal or pump seal
Excessive shaking or banging
The washer walks across the floor, thumps during spin, or sounds like something is loose inside.
Possible causes
- Worn shocks or suspension rods
- Damaged drum bearings
- Machine not level
Won't start
No lights, no response to buttons, or it clicks and hums without the cycle beginning.
Possible causes
- Door latch not engaging
- Control board or timer fault
- Power supply or wiring issue
Error codes
A code flashes on the display and the cycle stops, sometimes repeating every load.
Possible causes
- A sensor reporting a fault
- Drain, fill, or lock problem
- Electronic control issue
Seeing one of these? Describe it on the phone.
Call 360-324-5550How it works
What to expect when you call
Call with the symptoms
Tell us what the washer is doing and where you're located in Puyallup. Brand and model help if you have them handy.
Talk through the visit
Go over appointment availability and any diagnostic charge before anything is scheduled, so there are no surprises.
Diagnosis, then a quote
The washer is diagnosed and you receive a repair quote. Work begins only after you authorize it.
47.19° N, 122.29° W
Puyallup
Pierce County, Washington
Service area
Washer repair for Puyallup homes
This service is focused on households in Puyallup, Washington. Call with your address and we'll confirm whether it's within the current service area before setting anything up.
Call to confirm coverageBefore you call
Frequently asked questions
What information should I have when I call?
Your address so coverage can be confirmed, the washer's brand, whether it's a front-load or top-load machine, and a description of the problem. Note any error code on the display and when the trouble started.
Do I need the model number?
It isn't required to call, but it helps. The model number is usually on a label inside the door rim, under the lid, or on the back of the machine. If you can't find it, the technician can locate it during the visit.
How much will the repair cost?
Pricing depends on the diagnosis, the washer model, the parts needed, and the work involved. Discuss any diagnostic charge when you call, and receive a repair quote before deciding whether to go ahead.
How do I arrange an appointment?
Call 360-324-5550. We'll go over your washer's symptoms, your location, and the available appointment times, and set up a visit that works for you.